Watlow EZ-ZONE PM Bedienungsanleitung PDF herunterladen (Seite 18)

Watlow EZ-ZONE

PM Limit Controller • 15 • Chapter 2 Install and Wire

Removing the Mounted Controller from Its Case

1. Fromthecontroller'sface,pulloutthetabsoneachsideuntilyouhearitclick.

Pull out the tab on each side until you hear it click. Grab the unit above and below the face and pull

forward.

2. Grab the unit above and below the face with two hands and pull the unit out. On the PM4/8/9 controls

slide a screwdriver under the pry tabs and turn.

Returning the Controller to its Case

1. Ensurethattheorientationofthecontrolleriscorrectandslideitbackintothehousing.

Note:

The controller is keyed so if it feels that it will not slide back in do not force it. Check the orientation again

and reinsert after correcting.

2. Using your thumbs push on either side of the controller until both latches click.

Chemical Compatibility

This product is compatible with acids, weak alkalis, alcohols, gamma radiation and ultraviolet radiation.

This product is not compatible with strong alkalis, organic solvents, fuels, aromatic hydrocarbons, chlorinated

hydrocarbons, esters and keytones.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 110 111

Keine Kommentare

Watlow EZ-ZONE PM Bedienungsanleitung Seite 18