
Declaration of Conformity
Gateway Products
Watlow Winona, Inc.
1241 Bundy Blvd.
Winona, MN 55987 USA
Declares that the following product:
Model Numbers: EM(XX)-GATE-(XXXX), *NGW(X)-(XXXX)-(XXXX) X = any number or letter
Classification: Communications interface card, Installation Category I, Pollution degree II
Rated Voltage:
24V (ac or dc) or 5V (dc)
Rated Frequency: 50/60 Hz or dc
Rated Power: 10VA maximum
*NGW with 5V power option requires use of a Ferrico NF130 Clamp on ferrite on all lines to pass Class B
emissions. Depending on end use setup, this bead may or may not be necessary.
Meets the essential requirements of the following European Union Directives by using the relevant
standards show below to indicate compliance.
89/336/EEC Electromagnetic Compatibility Directive
EN 61326:1997 +A1:1998 Electrical equipment for measurement, control and laboratory
use – EMC requirements (Industrial Immunity, Class B
Emissions).
EN 61000-4-2:1996 +A1, 1998 Electrostatic Discharge Immunity
EN 61000-4-3:1997 Radiated Field Immunity
EN 61000-4-4:1995 Electrical Fast-Transient / Burst Immunity
EN 61000-4-5:1995 +A1, 1996 Surge Immunity
EN 61000-4-6:1996 Conducted Immunity
EN 61000-4-11:1994 Voltage Dips, Short Interruptions and Voltage Variations Immunity
EN 61000-3-2:1995 +A1-3:1999 Harmonic Current Emissions
EN 61000-3-3:1995 +A1:1998 Voltage Fluctuations and Flicker
Use of an appropriately approved class 2 power source is required for compliance.
2001/95/EC General Product Safety Directive
EN 61010-1:2001 Safety Requirements of electrical equipment for measurement,
control and laboratory use. Part 1: General requirements
Raymond D. Feller III Winona, Minnesota, USA
Name of Authorized Representative Place of Issue
General Manager July, 2003
Title of Authorized Representative Date of Issue
Signature of Authorized Representative
Kommentare zu diesen Handbüchern