Watlow MICRODIN Bedienungsanleitung Seite 8
- Seite / 106
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Overview
1.2 Watlow MicroDIN1.2 Watlow MicroDIN
Introduction to the MicroDIN Controller
The Watlow MicroDIN controller is a DIN rail-mounted, temperature controller.
It uses one input and two outputs, network connections and dozens of
parameters to satisfy a broad variety of control needs.
The single input can use either a thermocouple or RTD sensor. The single
control output provides an open collector or switched dc output signal for a
power switching device with a DC input. The single alarm output is an
electromechanical relay. The network connections allow as many as 32
controllers to be configured and monitored from a single personal computer.
You can configure, operate and monitor the MicroDIN almost entirely from a
PLC or personal computer via a serial connection using RJ-11 jacks. Indicator
lights on the face of the controller monitor error states, power, communications
activity and output activity.
Figure 1.2 - MicroDIN
inputs and outputs in a
thermal system
Address
Power
Comms
Alarm
Temperature Controller
MicroDIN
Temperature Controller
MicroDIN
Control
Output
Input
Error
Address
Power
Comms
Alarm
Temperature Controller
MicroDIN
Temperature Controller
MicroDIN
Control
Output
Input
Error
Address
Power
Comms
Alarm
Temperature Controller
MicroDIN
Temperature Controller
MicroDIN
Control
Output
Input
Error
Address
Power
Comms
Alarm
Temperature Controller
MicroDIN
Temperature Controller
MicroDIN
Control
Output
Input
Error
1 2 3 4
Communications Input and Output
to and from Personal Computer
Per Unit:
• Sensor Input from the process
• Control Output to the process
• Alarm Output about the process
1-32 devices/
EIA-485 Network
- MICRODIN 1
- User’s Manual 1
- Addendum 2
- Declaration of Conformity 3
- Meet the MicroDIN Team 4
- Safety Information 5
- Technical Assistance 5
- Your Feedback 5
- Table of Contents 6
- Chapter One: 7
- Setup Steps 9
- Indicator Lights 9
- Overview 10
- Chapter Two: 11
- Communications Setup 11
- Communications Overview 12
- EIA-485 Network 13
- Communication 14
- MicroDIN, A Modbus 15
- Remote Terminal Unit (RTU) 15
- Modbus Register Numbers 16
- Set Address/Baud Rate 17
- C D D C 18
- 8 None 1 1 19
- Chapter Three: 21
- Installation and Wiring 21
- Introduction 22
- Mounting the MicroDIN 23
- Figure 3.3 23
- Install and Wire 24
- To Mount MicroDIN 24
- To Dismount MicroDIN 24
- Input Wiring 26
- Output and Power Wiring 27
- Communications Wiring 28
- Wiring Examples 30
- Chapter Four: 33
- Features 33
- The System 34
- Power Limit 35
- Calibration Offset 36
- Filter Time Constant 37
- Sensor Selection 38
- Range Low and Range High 38
- Control Methods 39
- Proportional Control 40
- Alarm Set Points 43
- Alarm Hysteresis 43
- Process or Deviation Alarms 44
- Alarm Latching 44
- Alarm Silencing 45
- Panel Indicator Lights 46
- Open Loop Detect 46
- Bumpless Transfer 47
- Chapter Five 49
- Learn the Parameters 49
- System Group 50
- System Group continued 51
- Input Group 52
- Input Group continued 53
- Control Output Group 56
- Parameters 57
- Power Limit Set Point 57
- High Side Power 57
- Low Side Power 58
- Fixed Manual Output 58
- Operation Group 59
- Operation Group continued 60
- PID Group 61
- PID Group continued 62
- Alarm Output Group continued 66
- Error Group continued 70
- Characteristics Group 73
- Serial Number 2 74
- Software ID Number 74
- Software Revision 74
- Diagnostics Group continued 75
- Calibration Group continued 78
- Chapter Six: 81
- Operation and Calibration 81
- MicroDIN Startup 82
- MicroDIN Shutdown 83
- Operations 84
- • See p. 5.6 85
- Equipment Required 86
- Setup and calibration 86
- Appendix 87
- Writing a Modbus Application 88
- Packet Syntax 88
- Loop Back Command (0x08) 91
- Exception Responses 92
- Glossary 94
- Output #1: User selectable 99
- Output #2: User selectable 99
- A.14 Watlow MicroDIN 100
- Ordering Information 101
- 4.4, 5.6 102
- Watlow MicroDIN A.17 103
- Parameter Index 104
- Statement: 106
- Quality and 106
Verwandte Produkte und Handbücher für Sensoren Watlow MICRODIN
Sensoren Watlow LogicPro Bedienungsanleitung
(296 Seiten)
(296 Seiten)
Sensoren Watlow MLS Bedienungsanleitung
(142 Seiten)
(142 Seiten)
Sensoren Watlow Power Series Bedienungsanleitung
(72 Seiten)
(72 Seiten)
Sensoren Watlow Power Series Bedienungsanleitung
(72 Seiten)
(72 Seiten)
Sensoren Watlow Power Series Bedienungsanleitung
(28 Seiten)
(28 Seiten)
Sensoren Watlow Power Series Bedienungsanleitung
(28 Seiten)
(28 Seiten)
Sensoren Watlow Power Series Bedienungsanleitung
(72 Seiten)
(72 Seiten)
Sensoren Watlow Power Series Bedienungsanleitung
(28 Seiten)
(28 Seiten)
Sensoren Watlow QPAC Bedienungsanleitung
(34 Seiten)
(34 Seiten)
Sensoren Watlow SBL Card Bedienungsanleitung
(2 Seiten)
(2 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.066 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern