Watlow Silver Series Addendum Bedienungsanleitung PDF herunterladen (Seite 13)

Silver Series OIT  13  Watlow Addendum

For part numbers like… with… For PLC type choose… For PLC I/F choose…

PMxxxxx-2xxxxxx

EZKx-2xxx-xxxx

RMAx-x2xx-xxxx

Modbus RTU Modbus RTU Master RS-232 or RS-485 2W*

PMxxxxx-3xxxxxx

EZKx-3xxx-xxxx

RMAx-x3xx-xxxx

Modbus TCP Modbus TCP/IP Master Ethernet

Other Watlow Controllers Modbus RTU Modbus RTU Master RS-232 or RS-485 2W*

*Both 232 and 485 are available; choose the one to which you have connected the OIT.

11) For the Modbus RTU

Master…

• For COM, choose the

communications port to

which you have

connected the

controller. Typically

this is COM 1.

• For Baud rate, choose

the rate that is set in the

controller.

(004)

• For Data bits, choose 8 Bits.

• For Parity, choose None.

• For Stop bits, choose 1 Bit.

• For multiple controllers on the same port, for Turn around delay (ms), enter 15 and for Send

ACK delay (ms) enter 15.

• Click OK.

12) For the Modbus

TCP/IP Master…

• For IP address, enter

the IP address of the

controller.

• Click OK.

13) Click OK to close the

Device Properties

dialog.

(005)

14) To set up communications with controllers connected to other COM ports or to configure

additional controllers communicating via Ethernet:

• Click New...

• Repeat from step 7 above.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Watlow Silver Series Addendum Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Watlow Silver Series Addendum