Watlow Series PD Ethernet Enabled Temperature and Process Bedienungsanleitung PDF herunterladen (Seite 11)

Watlow Series PD ■ 9 ■ Chapter 2 Install and Wire

Warning:

Use National Electric (NEC) or

other country-specific standard

wiring and safety practices when

wiring and connecting this con-

troller to a power source and to

electrical sensors or peripheral

devices. Failure to do so may re-

sult in damage to equipment and

property, and/or injury or loss of

life.

WARNING: Process input may

not have sensor break protec-

tion. Outputs can remain full on.

Note: Install a 1kΩ pull-down

resistor for each digital in-

put using voltage inputs.

Note: Install a 10kΩ pull-up re-

sistor for each digital input

using contact closure in-

puts.

Figure 9a — Input 1, 0 to 20 mA Process Input

(all model numbers)

• Input impedance 100 Ω, dc only

• Controller does not supply power for the current loop

Figure 9b — Input 2, 0 to 20 mA Process Input

PDD _-_ _ _ _-_ _ _

• Input impedance 100 Ω, dc only

• Controller does not supply power for the current loop

• Input 2 isolated from Input 1

Dual Digital Inputs

PD_ 1-_ _ _ _-_ _ _

• Input impedance 10kΩ, dc only

• Input 2 isolated from Input 1

Figure 9c — Voltage input

0-1VÎ (dc) Event Input Low State

2-36VÎ (dc) Event Input High State

Figure 9d — Contact closure

0-2kΩ Event Input Low State

> 7kΩ Event Input High State

1 2 3 4

+5V‡ (dc)

Digital Common

Digital Input 1

Digital Input 2

10kΩ 10kΩ

Add a 10kΩ pull

up resistor for each

active input

1 2 3 4

Digital Common

Digital Input 1 +

Digital Input 2 +

1kΩ

Add a 1kΩ pull

down resistor for

each active input

5 6 7 8

9 10 11 12

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Kommentare zu diesen Handbüchern

Keine Kommentare

Watlow Series PD Ethernet Enabled Temperature and Process Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Watlow Series PD Ethernet Enabled Temperature and Process