Watlow EM Gateway Bedienungsanleitung PDF herunterladen (Seite 27)

Declaration of Conformity

Gateway Products

Watlow Winona, Inc.

1241 Bundy Blvd.

Winona, MN 55987 USA

Declares that the following product:

Model Numbers: EM00-GATE-0000, NGW0-0000-2400 and NGW0-0000-0000*

Classification: Communications interface card, Installation Category I, Pollution

degree II

Rated Voltage: 24V (ac or dc) or 5V (dc)

Rated Frequency: 50/60 Hz or dc

Rated Power: 10VA maximum

*NGW0-0000-0000 Requires use of a Ferrico NF130 Clamp on ferrite on all lines to pass Class B

emissions. Depending on end use setup, this bead may or may not be necessary.

Meets the essential requirements of the following European Union Directives by using the relevant

standards show below to indicate compliance.

89/336/EEC Electromagnetic Compatibility Directive

EN 61326:1997 With A1:1998 – Electrical equipment for measurement, control and

laboratory use – EMC requirements (Industrial Immunity, Class B Emissions).

EN 61000-4-2:1996 With A1, 1998 – Electrostatic Discharge Immunity

EN 61000-4-3:1997 – Radiated Field Immunity

EN 61000-4-4:1995 – Electrical Fast-Transient / Burst Immunity

EN 61000-4-5:1995 With A1, 1996 – Surge Immunity

EN 61000-4-6:1996 – Conducted Immunity

EN 61000-4-11:1994 Voltage Dips, Short Interruptions and Voltage Variations Immunity

EN 61000-3-2:1995 With A1-3:1999 – Harmonic Current Emissions

EN 61000-3-3:1995 With A1:1998 – Voltage Fluctuations and Flicker

Use of an appropriately approved class 2 power source is required for compliance.

Jim Boigenzahn Winona, Minnesota, USA

Name of Authorized Representative Place of Issue

General Manager February 28, 2002

Title of Authorized Representative Date of Issue

Signature of Authorized Representative

1 2 ... 22 23 24 25 26 27 28

Keine Kommentare

Watlow EM Gateway Bedienungsanleitung Seite 27